The spiral steel pipe is a spiral seam steel pipe which is made of steel coiled coil as raw material, which is often heated and extruded, and welded by automatic double wire double-sided submerged arc welding process. The spiral steel pipe feeds the strip steel into the welded pipe unit. After rolling through multiple rolls, the strip is gradually rolled up to form a circular tube blank with an open gap spiral steel pipe supplier. The reduction of the pressing roll is adjusted to control the weld gap in 1~ 3mm and make the ends of the solder joint flush.

Stacking requirements for spiral steel pipes

Stacking requirements for spiral steel pipes´╝Ü

  1. The principle requirement of spiral steel pipe stacking code is to ensure that the code is stable and safe, and that the materials of different varieties should be palletized separately to prevent entanglement and mutual erosion;
  2. It is forbidden to store articles that are erosive to steel in the vicinity of the spiral steel pipe;
  3. The bottom of the spiral steel pipe should be high, strong and flat to prevent the material from being damp or deformed;
  4. The same kind of materials are stacked separately according to the storage;
  5. the height of spiral steel pipe stacking, artificial homework does not exceed 1.2m, mechanical homework does not exceed 1.5m, and the width of the raft does not exceed 2.5m;
  6. Spiral steel tube steel stacked in the open air, there must be wooden mats or strips underneath, the sloping surface is slightly inclined to facilitate drainage, and pay attention to the flatness of the material to prevent bending deformation;
  7. There should be a certain passage between the raft and the raft. The inspection road is generally 0.5m. The access passage depends on the material size and the transport machinery, generally 1.5~2.0m;
  8. The bottom of the raft is high. If the warehouse is a cement floor of the sunny side, the height of the lining is 0.1m; if it is muddy, the height must be 0.2~0.5m. If it is an open space, the concrete floor height is 0.3-0.5m, and the sand surface is 0.5-0.7m high;
  9. The open-pitger angle steel and channel steel should be placed downside down, that is, the mouth should face downward, the I-beam should be placed vertically, and the I-groove surface of the steel should not face upwards to avoid rusting of the water.
Stacking requirements for spiral steel pipes

Leave a Reply

Your email address will not be published. Required fields are marked *